Dish Network DuoDVR ViP 722_TOC - Manual (Page 49)

Connections and Setup
103
Connecting to the Remote TVs (TV1 or TV2)
C
ONNECTING TO THE
R
EMOTE
TV
S
(TV1
OR
TV2)
This section describes how to connect the receiver H OME D ISTRIBUTION connection to the
cable-ready remote TV located in another room away from the receiver. You can use
these instructions to connect TVs in your house to see programming from TV1 or TV2.
This installation uses your in-home cable system. If your house does not have built-in
cabling, it will be necessary to run cables from the receiver to each remote TV. Due to the
difficulty of this installation, you should consider having this professionally installed. Call
DISH Network at 1-800-333-DISH (3474).
If you’re using TV1 in a room away from the receiver, be sure to order the replacement
remote control that uses UHF Pro signals instead of IR. Call your DISH Network retailer or
go to www.dishnetwork.com, select our Products, and then click on Accessories.
When connecting to the HOME DISTRIBUTION coaxial port, you must meet the FCC
requirements in the Appendix. To meet these requirements, an in-line coaxial attenuator
has been included with your receiver and may need to be installed using the following
guidance:
• If connecting to your in-home cabling system to distribute the signal to a TV(s) in other
rooms, in most cases you will not have to install the attenuator on the H
OME
D ISTRIBUTION port for typical in-home cabling systems.