Dish Network DuoDVR ViP 722_TOC - Manual (Page 24)

Chapter 10
78
Controlling Other Components
Checking the Device Codes
Use these steps to find the device code you’ve set for each remote control mode (TV, VCR, and
AUX)
.
Instructions Additional Information
1. Press and hold the mode button until all the
other mode buttons light up, and then
release the button. The mode button
flashes. For example, hold TV until all of the other mode buttons
light. When you let go, TV will flash.
2. Press the Pound (#) button twice.
Watch the mode light to determine your
code. The mode button flashes the number
for each digit of the device code, with a
pause between the groups of flashes. A
quick flash is for zero. For example, if the code is 570, the mode button flashes
five times, pauses, flashes seven times, pauses, and
flashes once quickly.
Instructions Additional Information
For AUX mode: The first group of flashes tells
you what the AUX mode controls. A quick flash
(zero) before the three-digit code is for a TV,
one regular flash is for a VCR, and two flashes
is for a tuner, or amplifier. For example, if the TV code is 570, the AUX mode button
flashes once quickly (indicating 0 for TV), pauses, flashes
five times, pauses, flashes seven times, pauses, and
flashes once quickly.
For a satellite receiver programmed in AUX
mode: The AUX mode button will flash the
same number of times as the address number. For example, if the receiver address is 3, the AUX mode
button flashes three times.
For Limited Mode: If you have programmed a
TV or VCR in Limited Mode, the mode button
flashes once at the end of the flash sequence. For example, if the TV code is 570, the AUX mode button
flashes once quickly (indicating 0 for TV), pauses, flashes
five times, pauses, flashes seven times, pauses, flashes
once quickly, and then flashes once (indicating Limited
Mode).
1
2
Watch the Mode button
and count the flashes
Press & hold the Mode
button until all Mode
buttons light up
VCR
VCR
# #
Press POUND
twice