Dish Network DuoDVR ViP 722_TOC - Manual (Page 34)

Chapter 11
88
Using Shared View
Using Shared View
Shared View is a feature of Single Mode that lets you activate the TV2 audio and video outputs to
display the same programming as the TV1 outputs. While using this feature, both Remote Control
1 and Remote Control 2 for your satellite receiver can control what is displayed on all TVs
connected to the system. This feature is available only in Single Mode.
Note: Make sure you are using Remote Control 1 and TV1 because you cannot enable or disable
this feature using Remote Control 2.
Note: If you do not want to display programming on any other TV besides TV1 and you do not want
Remote Control 2 to control the receiver, select Disable View. After you select Done, TV2 will
show a screen that says Shared View is currently disabled.
Modulator Setup
If you have TV1 and TV2 connected to the receiver with coaxial cables (see page 103), you can
decide which channel you’d like to use to view your DISH Network programming. If you have the
system locked, you’ll have to enter the password to enable TV1’s output on this screen. Make sure
your TV can tune to the channel you pick before you change the setting on this screen.
1
2
3
4
Make sure
receiver is in
Single Mode
Press MENU, select
System Setup then
select Shared View
Select Done
Done
Select Enable
(or Disable) View
MENU
Program Guide 1
Themes & Search 2
Customer Support 3
Multimedia 4
Locks 5
System Setup 6
Daily Schedule 7
Preferences 8
Cancel 0
1 Main Menu Thursday, January 20
114 E! 114 E! 6:25 pm
Celebrity Homes 5:30 pm - 7:00 pm NR
System Setup 6
Shared View 2