BECKHOFF IPxxxx-B520 - Manual (Page 32)

Analog Output Channel Object
29 IPxxxx-B520
Instance Attributes
100
(64hex)
get/set
1
Register 0 DWORD Value of Register 0 of
the
analog output
channel
See semantics
: : : : : :
106
(6Ahex)
get Register 6 DWORD Diagnosis Register See semantics
: : : : : :
163
(A3hex)
get/set
1
Register 63 DWORD Value of Register 63 of
the
analog output
channel
See semantics
170
(AAhex)
get Value Length USINT Value length in Bytes
1: before writing the registers the write protection of the registers has to be disabled.
Semantics
Status
The Status of an Analog Output Point indicates the following conditions:
Value Description
0 OK, no failure
1 internal IO Error
Idle Mode, no Output data via DeviceNet
Diagnostics (depends on IPxxxx, see manual)
dle Mode, no Output data via DeviceNet
Fault State / Idle State
The attribute values are according to the adjustment of the “IO Error Action
Attribute” of the IP Config Object. (see chapter IP Config Object)
Value Description
0 hold last state
1 Low Limit, reset output