Caple CR13400 - Manual (Page 12)

12
Conversion to LPG
J
Fig. 3.3b
Fig. 3.3a
J
F
Fig. 3.4
Minimum burner setting
adjustment
In the minimum position the flame must
have a length of about 4 mm and must
remain lit even with a quick turn from the
maximum position to that of minimum.
The flame adjustment is done in the fol-
lowing way:
– Turn on the burner
– Turn the tap to the MINIMUM position
– Take off the knob
– With a thin screwdriver pass by the
hole of microswitch and turn the screw
F until adjustment is correct (fig. 3.4).
Normally for G30/G31, tighten up the
regulation screw.
The burners are conceived in such a
way so as not to require the regula-
tion of the primary air.
Conversion procedure
Injectors replacement
Select the injectors to be replaced
according to the “Table for the choice of
the injectors” (page 13).
Injectors not supplied can be
obtained from the After-Sales
Service.
To replace the injectors proceed as fol-
lows:
- Remove pan supports and burners
from the cooktop.
- Using a wrench, substitute the nozzle
injectors “J” (fig. 3.3a, 3.3b) with those
most suitable for the kind of gas for
which it is to be used.