Caple CR13400 - Manual (Page 5)

5
1 - Electrical Installation
Connecting feeder cable
To connect the feeder cable to the
cooker it is necessary to:
– Remove the 6 screws that hold
shield A behind the cooker.
– Open completely the cable clamp D.
– Position the U bolts onto terminal block
B (fig. 1.1) according to the diagram in
fig. 1.2 and fig. 1.3.
– Insert the feeder cable into the cable
save P. The supply cable must be of
a suitable size for the current require-
ments of the appliance; see the
section “Feeder cable section”.
– Connect the phase and earth cables
to terminal B according to figures 1.2
and 1.3.
– Pull the feeder cable and block it
with the cable clamp D
– Re-mount shield A.
N.B. The earth conductor must be left
about 3 cm longer than the others.
Fig. 1.1
PE
1 2 3 4 5
N (L
2
) L
1
230 V
Fig. 1.2
Feeder cable section
type H05RR-F
230 V 3 x 4 mm 2 (**)
(**) – Connection with wall box connection.
– Diversity factor applied
– A diversity factor may be applied to
the total loading of the cooker only
by a suitable qualified person.
23
4
5
1
230 V ~
N
(L 2 )
PE
L1
Red
or
Brown
(Live)
Black
or
Blue
(Neutral)
Green
and
Yellow
(Earth)
Fig. 1.3
PE Earth
N Neutral
L Live
P
D
A
B