Caple CR13400 - Manual (Page 16)

16
How To Use the Hob Burners
Hob burners
Each hob burner is controlled by a
separate gas tap operated by a control
knob (fig. 4.3) which has 3 positions
marked on the knob, these are:
– Symbol ● : tap closed (burner off)
– Symbol : High (maximum)
– Symbol : Low (minimum)
Push in and turn the knob anti-clockwise
to the selected position.
Low High
Lighting of the hob burners
To ignite the burner, the following instructions are to be pursued:
1) Lightly press and turn the knob anti-clockwise, and make the symbol printed
on the knob to mach with the indicator on the control panel (fig. 4.3).
2) Press the knob to operate the electric ignition; or, in case of power cut, approach a
flame to the burner.
3) Adjust the burner according to the power required.
If the burner flame should go out for some reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to the closed
●
position, wait for at least 1
minute and then repeat the lighting procedure.
If your local gas supply makes it difficult to light the burner with the knob set to maximum,
set the knob to minimum and repeat the operation.
- The electric ignition is incorporated in the knobs ( ★ symbol beside flame - max.
heat/max. gas flow fig. 4.3).
- The maximum setting permits rapid boiling of liquids, whereas the minimum setting
allows slower warming of food or maintaining simmering conditions of liquids.
- Other intermediate operating can be achieved by positioning the control knob indicator
between the maximum and minimum setting, but not between the maximum and off
positions.
N.B. When the cooker is not being used, set the gas knobs to their closed positions
and also close the cock valve on the gas bottle or the main gas supply line.
Fig. 4.3