Cloud Electronics CDPM Range - Manual (Page 16)

CDPM Digital Paging Microphone Setup And Installation Guide
CLOUD ELECTRONICS LIMITED
Table 8.1: Default Jumper Settings
When removing jumpers we recommend that the link remain connected to one leg of the header, to
prevent loss of the link.
When making internal adjustments please ensure that you:
• Disconnect power to the unit before deconstructing. Where the microphone is powered from
another unit, this will mean removing the connection to that unit. For access terminal block
connections, this is best achieved at the mixer end of the connection.
• Only reassemble the unit using the original screws or screws identical to the originals.
Fig 8.1: Jumper locations on CDPM main PCB
J1 +1 to Chime Select ON
J2 +2 to Chime Select OFF
J3 +4 to Chime Select OFF
J4 Terminate Buss ON
J5 Chime On/Off ON
J6 Internal Chime On/Off ON
J7 NVM Reset OFF
J8 Priority OFF
J9 Group Lock OFF
J10 Auto Zone Reset ON
J11 +8 to Bank Offset OFF
J12 +4 to Bank Offset OFF
J13 +2 to Bank Offset OFF
J14 +1 to Bank Offset OFF
10
V1 210605