3 remote commands and queries – Comtech EF Data CDD-880 User Manual
Page 108
CDD-880 Multi Receiver Router
Revision 1
Serial-based Remote Product Management
MN-CDD880
6–8
6.3
Remote Commands and Queries
The Serial Command Line interface (CLI) (the Controller), shown previously in , is used to issue remote commands and queries to the
CDD‐880 (the Target). From the CLI command prompt CDD‐880> type in the command or query packet, using the format explained
previously, for transmission to the CDD‐880.
For example: CDD‐880><0000/LC1=3[cr]
The table that follows provides a ‘quick reference‘ to the Instruction Codes available at present for M&C of the CDD‐880. The ‘C’ and ‘Q’
columns, when marked with an ‘X’, denote whether that Instruction Code is Command Only, Query Only, or Command and Query.
INSTRUCTION
CODE
USED TO...
C
Q
Page
DPW
Set default passwords
X
5‐9
IG1
Set or query the IP Address and network prefix for the GE 10/100/1000 Gigabit Ethernet Port
X
X
5‐9
IPA
Set or query the IP Address and network prefix for the GE 10/100/1000 Gigabit Ethernet Traffic
/ Management port
X
X
5‐10
LC1
Set or query the link configuration for the GE 10/100/1000 Gigabit Ethernet Port
X
X
5‐10
MAC
Query the unique router MAC Address
X
5‐10
MG1
Query the unique GE port MAC Address
X
5‐10
MLC
Set or query the link configuration for the FE Port
X
X
5‐10
NPS
Query the negotiated port speeds for the GE and FE ports
X
5‐11
SRC
Set or query the SNMP Read Community String
X
X
5‐11
SWC
Set or Query the SNMP Write Community String
X
X
5‐11