Document Outline

• HPCST-5000 Rev.0 Cover
• Preface
  • About this Manual
  • Conventions and References Used in this Manual
    • Cautions and Warnings
  • Reporting Comments or Suggestions Concerning this Manual
  • Customer Support
• Table of Contents
• Chp1 INTRODUCTION
  • Description
  • Applications
  • Options
  • Configurations
    • Single Thread Configuration
    • Redundant System
  • Component Descriptions
    • Radio Frequency Transceiver (RFT)
    • Low Noise Amplifier (LNA)
    • Solid-State Power Amplifier (SSPA)
    • Monitor and Control (M&C)
    • 1:1 Redundant LNA Plate
    • Redundant Switch Unit (RSU)
    • KP-10 Hand-Held Keypad (Optional)
  • High-Power C-Band Satellite Terminal Models
  • HPCST-5000 Specifications
    • Prime Power Specification
    • System Interfaces
    • System Environment Specification
    • HPCST-5000 Monitor and Control
    • System Receive Characteristics
    • System Transmit Characteristics
    • Leading Particulars
  • RFT Specification
  • C-Band SSPA Specification
  • LNA Specification
  • Dimensional Drawings
• Chp2 EXTERNAL CONNECTIONS
  • External Connections
    • RFT External Connections
      • TX/IF Input (J1)
      • TX/RF Output (J2)
      • RX/IF Output (J3)
      • RX/RF Input (J4)
      • Prime Power (J5)
      • Serial Remote Control (J6)
      • Ground (GND)
    • C-Band SSPA External Connections
      • RF Input (J1)
      • Gain Control (J2)
      • Discrete Interface (J3)
      • RF Output Monitor Port (J4)
      • Prime Power (J5)
      • RF Output (J7)
      • Alarm/Interface Board
• Chp3 Single Thread Configuration
  • Unpacking
  • Inspecting the Equipment
    • Included Parts
  • RFT Installation
    • Tools Required
    • Vertical Pole Installation
      • Round Pole
      • Square Pole
    • Spar Installation
  • LNA Installation
  • C-Band SSPA Installation
    • C-Band SSPA Installation
    • Vertical Pole Installation
      • Round Pole
      • Square Pole
    • Spar Installation
• Chp4 REDUNDANT SYSTEM INSTALLATION
  • Unpacking
  • Inspecting the Equipment
    • Included Parts
  • RFT Installation
    • Tools Required
    • Vertical Pole Installation
      • Round Pole
      • Square Pole
    • Spar Installation
    • 1:1 Redundant Plate Installation
    • 1:1 Redundant C-Band SSPA Installation
      • Round Pole
      • Square Pole
    • Spar Installation
  • Redundancy Configuration Cabling Matrix
• Chp5 OPERATION
  • System Operation
  • Remote Control
  • Front Panel Display/Keypad
    • Front Panel Controls
  • Main Menu
    • Configuration
    • Monitor
    • Faults
• Chp6 THEORY OF OPERATION
  • Monitor and Control
    • EEPROM Memory
    • Remote Interface
      • Remote Interface Specification
    • Terminal Default Conditions
    • Theory of Operation
    • M&C Board Connector Pinouts
      • EIA-232/EIA-485 Remote Control (J1)
      • Remote Relay Control, J2 DB15-Female
      • HPA, PS, U/C, and D/C, J3 DB37-Male
      • Synthesizers (DC/UC/LO), J4 DB37-Female
      • Keypad Display, 24-Pin (12 x 2) Ribbon Connector (J5)
    • Test Points and LEDs
  • High Stability Oscillator
    • Specifications
  • IF Local Oscillator
    • Specifications
  • Synthesizer
    • Specifications
    • Theory of Operation
  • Down Converter
    • Specifications
    • Theory of Operation
  • Up Converter
    • Specifications
    • Theory of Operation
• Chp7 MAINTENANCE
  • Test Points and LEDs
  • Fault Isolation
• Chp8 EQUIPMENT LIST
  • Equipment List
  • Detail Equipment List
    • LNA Connector Kit
    • Cable Kit
    • Spar Mounting Kit
    • Universal Mounting Kit
• Appendix A CONFIGURATIONS
  • 140 MHz Configuration
    • IF 1112.5 MHz Local Oscillator
      • Specifications
    • Synthesizer
      • Specifications
      • Theory of Operation
    • Down Converter
      • Specifications
      • Theory of Operation
    • Up Converter
      • Specifications
      • Theory of Operation
• Appendix B REMOTE CONTROL OPERATION
  • General
  • Message Structure
    • Start Character
    • Device Address
    • Command/Response
    • End Character
  • Configuration Commands/Responses
  • System
  • Status Commands/Responses
• Glossary
• Index