Comtech EF Data CIM-300L - Manual (Page 99)

CiM-300L IP Enabled Satellite Modem Rev. 1
Serial Remote Control CD/CIM300L.IOM
73
Parameter Type Protocol Description
LNB Power Command:
Response:
Status:
Response: <add/LNB_xxx'cr'
>add/LNB_xxx'cr''lf']
<add/LNB_'cr'
>add/LNB_xxx'cr''lf']
Where: xxx = ON or OFF.
LNB Voltage Command:
Response:
Status:
Response: <add/LNBV_xxx'cr'
>add/LNBV_xxx'cr''lf']
<add/LNBV_'cr'
>add/LNBV_xxx'cr''lf']
Where: xxx = 13,18, or 24 Volts
LNB
Reference
Enable Command:
Response:
Status:
Response: <add/LNBR_xxx'cr'
>add/LNBR_xxx'cr''lf']
<add/LNBR_'cr'
>add/LNBR_xxx'cr''lf']
Where: xxx = ON or OFF.
LNB Power
Monitor Low
Current
Threshold Command:
Response:
Status:
Response: <add/LNBL_xxx'cr'
>add/LNBL_xxx'cr''lf']
<add/LNBL_'cr'
>add/LNBL_xxx'cr''lf']
Where: xxx = 0 to 500 in 1 mA steps
LNB Power
Monitor High
Current
Threshold Command:
Response:
Status:
Response: <add/LNBH_xxx’cr’
>add/LNBH_xxx’cr’’lf’]
<add/LNBH_’cr’
>add/LNBH_xxx’cr’’lf’]
Where: xxx = 0 to 500 in 1 mA steps
5.4.3 I
NTERFACE
C
ONFIGURATION
C
OMMANDS
Parameter Type Protocol Description
Interface
Transmit
Overhead
Type Command:
Response:
Status:
Response: <add/ITOT_xxxxx'cr'
>add/ITOT_xxxxx'cr''lf']
<add/ITOT_'cr'
>add/ITOT_xxxxx'cr''lf']
Where: xxxxx = NONE*
*Note: TE: CiM-300L only
Interface
Receive
Overhead
Type Command:
Response:
Status:
Response: <add/IROT_xxxxx'cr'
>add/IROT_xxxxx'cr''lf']
<add/IROT_'cr'
>add/IROT_xxxxx'cr''lf']
Where: xxxxx = NONE*
*Note:
CiM-300L only
External
Clock-
Reference
Frequency
Command:
Response:
Status:
Response: <add/ERF_nnnnn.n'cr'
>add/ERF_nnnnn.n'cr''lf']
<add/ERF_'cr'
>add/ERF_nnnnn.n'cr''lf']
Where: nnnnn.n = 8.0 to 10000.0 (external clock frequency in
kHz).