Comtech EF Data SNM-1010L - Manual (Page 124)

SNM-1010L Data/Control Modem Revision 0
User Port Operation MN/SNM1010L.OM
4.3.5 Receive Control Channel Frequency (ICF)
This command sets the receive (NMS to remote) control channel IF frequency at the
remote node.
4.3.5.1 Command Format
ICF <frequency>'cr'
<frequency> Entered in MHz.
Range of 950 to 1750 MHz
Resolution of 100 Hz.
Formatting is pseudo-floating point.
Example :
ICF 1078.4567 sets receive control IF frequency to 1078.4567 MHz.
4.3.5.2 Local Command Responses
ICF= <frequency>, <control channel offset>, <traffic channel offset>
4.3.6 Transmit Control Channel Frequency (OCF)
This command sets the transmit (remote to NMS) control channel IF frequency at the
remote node.
4.3.6.1 Command Format
OCF <frequency>'cr'
<frequency> Entered in MHz.
Range of 950 to 1750 MHz
Resolution of 100 Hz.
Formatting is pseudo-floating point.
Example :
OCF 1078.1234 sets transmit control IF frequency to 1078.1234 MHz.
4.3.6.2 Local Command Responses
OCF= <frequency>, <control channel offset>, <traffic channel
offset>
4.3.7 Transmitter On (RF_ON)
4–6