Comtech EF Data SNM-1010L - Manual (Page 130)

SNM-1010L Data/Control Modem Revision 0
User Port Operation MN/SNM1010L.OM
4.3.14 Echo (ECHO)
This command enables/disables echo of characters sent to the SNM-1010L user port.
4.3.14.1 Command Format
ECHO <state> ‘ON’ enables character echo
‘OFF’ disables character echo
4.3.14.2 Local Command Responses
ECHO <state>
4.3.15 Modem Command Sequence
This command permits the use of the User Port to communicate with the SNM-1010L
using M&C commands similar to those used for the SDM-300L base modem.
Refer to Appendix A, Remote Control Specification, for a subset of M&C remote
commands that may be useful to the SNM-1010L.
4.3.15.1 Command Format (MC)
<channel_no> MC 'modem command string''cr'
<channel_no> Prefix channel number. (Optional)
Valid range: 0 (or omitted)
MC The command string following the 'MC' command is issued directly to the
SNM-1010L. Refer to Section 9.0.
4.3.15.2 Local Command Responses
>1/’response’’cr’
4–12