Appendix b. lbc-4000 redundancy operation, B.1 introduction, B.2 redundancy operations overview – Comtech EF Data LBC-4000 User Manual

Page 131

Advertising
background image

B–1

Appendix B. LBC-4000

REDUNDANCY OPERATION

B.1

Introduction

The LBC‐4000 L‐Band Up/Down Converter System with Ethernet can optionally be configured for 
redundant  system  operation.  This  appendix  provides  detailed  information  for  cabling  and 
otherwise configuring the LBC‐4000 for 1:1 redundancy.  

B.2

Redundancy Operations Overview

• Figure B‐1 provides a functional schematic for LBC‐4000 redundant operation.  

 

• Figure B‐2 illustrates the cabling requirements for redundant operation.  

 

Note the following: 

 

o

BNC connections, where applicable, use 50Ω BNC male‐to‐male cables. 

 

o

It  is  recommended  that  all  Type  ‘N’  to  Type  ‘SMA’  cable  connections  are  best 
accomplished using a Type ‘N’ male to Type ‘SMA’ female adapter, then using Type 
‘SMA’ female‐to‐female cables.

• Sect. B.3 addresses the control and configuration of an LBC‐4000 Redundancy System 

via the LBC‐4000 front panel. 

 

• Sect. B.4 addresses the control and configuration of an LBC‐4000 Redundancy System 

via the LBC‐4000 Web Server Interface.  

 

• Sect. B.5 addresses the control and configuration of an LBC‐4000 Redundancy System 

via serial remote control.  

 
 
 
 
 

Advertising