Comtech EF Data LBC-4000 - Manual (Page 67)

LBC-4000 L-Band Up/Down Converter System with Ethernet Revision 2
Front Panel Operation MN-LBC4000A
5–11
CONFIG: ETHERNET
Æ SNMP Æ TRAPS
TRAPIP1 TRAPIP2 VERSION
Use the [←][→] arrow keys to select TRAPIP1, TRAPIP2 or VERSIONS, and then press
[ENT].
When TRAPIP1 or TRAPIP2 is selected:
Trap IP Address #X:
000.000.000.000
(Where X = 1 or 2) To edit the Trap Destination IP Address: Use the [←][→] arrow keys
to select a digit to edit, and then use the [↑][↓] arrow keys to change its value. Press
[ENT] when done.
When VERSION is selected:
Trap Version:
SNMPv1 SNMPv2
Use the [←][→] arrow keys to select the Trap Version as SNMPv1 or SNMPv2, and then
press [ENT].
5.2.1.3 CONFIG: REDUND (Redundancy)
Redundancy:
Mode State FrcBkup
Appendix B. LBC‐4000 REDUNDANCY OPERATION