Comtech EF Data CDD-56X Series Vipersat - Manual (Page 38)

Menu Descriptions MN/22137, rev 1
3-4 Vipersat CDD-56X Series User Guide
Figure 3-2 Administration screen
Ensure that the Working Mode is set to Router-Vipersat.
If it is not, enter C at the command prompt and change the setting by selecting
4, as shown in figure 3-3. The unit will reboot automatically in order to imple-
ment the change for this setting.
Figure 3-3 Working Mode dialog
Note: If the Router-Vipersat option does not appear as a selection, the Vipersat
Feature Code has not yet been entered into this unit. Input the Vipersat
code as described in the next section..
From the Administration menu, enter an F at the prompt to display the Feature
Configuration screen shown in figure 3-4.
NOTE