Comtech EF Data CDD-56X Series Vipersat - Manual (Page 87)

Chapter 3 - Using the Command Line Interface (CLI) 3-53
MN/22137, rev 1 Vipersat Configuration
Figure 3-70 Vipersat Migration prompt
UDP Port Base Address
Should a particular network application require a specific UDP port base
address be used, the default address can be changed by entering U at the
command prompt in the Vipersat Configuration screen (figure 3-6).
Figure 3-71 UDP Port Base Address prompt
Caution: This command affects all communications for the VMS and STDMA.
If the base address is changed, it must be changed in the VMS as
well as in all modems in all networks controlled by the VMS. The base
address must also be changed when using VLOAD with this network.
Alerts
The Alerts menu item in the Vipersat Configuration screen is for information
only and serves to display alert messages to the operator.