Comtech EF Data CDD-56X Series Vipersat - Manual (Page 85)

Chapter 3 - Using the Command Line Interface (CLI) 3-51
MN/22137, rev 1 Vipersat Configuration
Note that Coding Rate 6 (1/1) is not a valid selection when operating in Vipersat
mode with Turbo Product Coding.
Receive Modulation Type
Enter Q to use the dialog shown in figure 3-68 to set the Receive Modulation
Type for the selected Demod’s Home State.
Figure 3-68 Receive Modulation Type prompt
Vipersat Summary
The Vipersat Summary screen can be viewed by entering D at the command
prompt in the Vipersat Configuration screen (figure 3-6).
Figure 3-69 Vipersat Summary screen