Comtech EF Data Vipersat Load Utility v3.5.x - Manual (Page 36)

Main Window Description
3-12 VLoad User Guide
Caution: Note that some actions, such as the Put command, may require
several minutes to be performed. Once an action is initiated, do not
attempt a subsequent action until the progress status (both the text
information and the progress bar(s)) indicates that the first action is
either completed, failed, or is terminated with the Cancel button.
Set Defaults / Clear
The upper button in the Progress area of the main window is a dual function
button. When no progess status information is displayed, the button label
appearance is Set Defaults. Clicking this button resets most VLoad parameters
to their initial default settings, as listed below.
• Unit List
• Column order: IP Address, Type, Serial #, App Ver, Base Ver
• Column widths: 100, 90, 90, 72, 90 pixels
• Row order: ascending IP address
• For each unit
• Transfer rate: 900 Kbps
• Port number: c001 hex (hard-coded)
• Attempts: 3 iterations
• Timeout: 3 seconds
• Reset type: hard
• Application
• Next image to run: unchecked (current modem setting)
• Next image to save: unchecked (current modem setting)
• Next image to get: unchecked (current modem setting)
• Flash timeout: 90 seconds (hard-coded)
• Base Modem
• Next image to run: unchecked (current modem setting)
• Next image to save: unchecked (current modem setting)
• Flash timeout: 120 seconds (hard-coded)
• Configuration
• Get from: active
• Put to: active only
• Flash timeout: 30 seconds (hard-coded)
• Unit Information
• FAST code: none
• Device type: none
• Serial number: none
• Name: none
• Version: none
• Network ID: none