DAHON Service Manual - Manual (Page 11)

WARNING:
If the hinge is too tight this can cause
damage to the hinge.
WARNING:
If the hinge is too tight this can cause
damage to the hinge.
WARNING:
If the hinge is too tight, this can
cause damage to the hinge.
RADIUS V
RADIUS
VYBE
Adjusting the Handlepost Hinges
TIGHTEN:
Follow the arrows on
which way to turn the
latch bolt.
LOOSEN:
Follow the arrows on
which way to turn the
latch bolt.
Radius V - to make adjustments, use a 6mm
wrench to tighten or loosen. An adjustable
wrench or small pliers can also be used if a
6mm wrench is not available.
Radius - to make adjustments, use an 8mm
wrench to tighten or loosen. An adjustable
wrench or small pliers can also be used if an
8mm wrench is not available.
Vybe - to make adjustments, use a 6mm
wrench to tighten or loosen. An adjustable
wrench or small pliers can also be used if
a 6mm wrench is not available.
Adjust the latch bolt until the latch is able to
open and close with a 29-49 Nm force.
Adjust latch bolt until latch is able to open
and close with a 29-49 Nm force.
Adjust latch bolt until latch opens and closes
with 29~49 Nm force.
NOTE:
To avoid over tightening or loosening the hinge, make adjustments in small(1/16) increments.
11
NOTE:
If the hinge is very tight, please clear off
dirt and add lubricating oil.