DAHON Service Manual - Manual (Page 16)

WARNING:
If the hinge is too tight, it could cause tension and damage to the frame.
NOTE:
While adjusting a V-Clamp hinge, turn in increments of 1/16 for the best result in securing
the hinge. Failure to effectively adjust the hinge could result in the hinge being too tight
or too loose.
Adjust the hinge bolt to allow the hinge to open and close with the same amount
of force (39~88 Nm).
VERSION A*
VERSION B*
TIGHTEN:
As indicated above, face the hinge and turn
the screw upwards (counter-clockwise). As indicated above, face the hinge and turn
the screw downwards (clockwise).
LOOSEN
*TOOLS NEEDED: 8 mm wrench
* Use an 8 mm wrench (you can also use an adjustable wrench or small pliers) to adjust the hinge.
TIGHTEN:
As indicated above, face the hinge and turn
the screw downwards (counter-clockwise). As indicated above, face the hinge and turn
the screw upwards (clockwise).
LOOSEN
16