DAHON Service Manual - Manual (Page 18)

WARNING:
The LockJaw hinge can ONLY be opened
with the OC bolt.
WARNING:
As a general rule, the pivot bolt will not need
any adjustment. Do NOT try to open the
LockJaw hinge with the pivot bolt. ONLY open
the Lockjaw hinge with the OC bolt and only
adjust the tension with the adjustment bolt.
WARNING:
If you are unsure of how to make
proper adjustments to your bicycle,
seek a qualified bicycle technician for
professional advice on adjustments.
LockJaw Hinge Adjustment
Bikes equipped with the LockJaw hinge look like
your average bike. In order to see the LockJaw,
pinpoint where the bike folds. Read the following
directions carefully to ensure safety when
using the LockJaw hinge with your bike.
Tools Needed: • 6 mm Allen key
• 2.5 mm Allen key
• 2 mm Allen key
The Lockjaw hinge (located on the top tube and
on the down tube) has three components, each
fulfilling a different function.
OC Bolt – Allows the LockJaw hinge to open and
close. It is secured by a special Safety Screw
(Version B only).
Adjustment Bolt – Adjusts the tension of the
LockJaw mechanism.
Pivot Bolt – Is the actual hinge axle where the two
halves rotate on the frame. The pivot bolt can be
adjusted to tighten or loosen the hinge.
Overview
There are two versions of the LockJaw
available. Check your bike to determine
which LockJaw version is used and
apply the appropriate instructions.
The Lock Screw and the Pivot Bolt
are the same for both versions.
On Version B, adjustment bolts
contain an additional safety screw
(located inside the Adjustment Bolt).
See the different versions below.
Adjustment
Bolt
Safety
Screw
OC Bolt
Pivot Bolt
Version B
Adjustment
Bolt
OC Bolt
Pivot Bolt
Version A
Adjustment Bolt
Pivot Bolt
Lock Screw
18