Daktronics AF-3400-12-RGB - Manual (Page 27)

4.6 Ethernet Communication
If the communication system is Ethernet, look for:
• a network card in the computer connecting to a network jack on the wall.
• a network jack similar to an oversized phone jack.
Figure 16: Ethernet Communication Layout
Connections
• Computer to network jack − RJ45 cable (similar to phone cable) from computer port to
network server in building.
• Network to surge board − RJ45 cable from hub or router to surge board in enclosure at
display.
• Enclosure at display to display − quick-connect cable from enclosure to middle jack on
back of display.
Troubleshooting
Component Check
Cable
Connections
•
The network cable connects the computer to the network port on the wall.
•
The wire from the server is connected to the input port on the Ethernet surge board.
•
The quick-connect cable runs from the enclosure to the middle jack on display back.
Display
Power
•
The display is either running a message or showing a single pixel flashing in the bottom
right corner of the display when power is on.
Software
•
The software is configured for TCP/IP communication.
•
The software and the display are set for the same network address.
•
Refer to the software manual for other possible conditions.
Signal Overview 21