DFI PIC-H61 - Manual (Page 20)

www.dfi .com
20
Chapter 2 Hardware Installation
Chapter 2
I/O Connectors
The 8-bit Digital I/O connector provides powering-on function to external devices that are
connected to these connectors.
8
1
1
4
+12V
Ground
5VSB
+5V
Digital I/O power
Digital I/O
Digital I/O Connector
Digital I/O Power Connector
Digital I/O Connector
Pins Function
1 DIO7
2 DIO6
3 DIO5
4 DIO4
5 DIO3
6 DIO2
7
DIO1
8 DIO0
SATA (Serial ATA) Connectors
7
RXN
GND
TXP
TXN
GND
1
RXP
GND
SATA 2.0 3Gb/s
Features
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu (“SATA Configuration” submenu) of the
BIOS. Refer to chapter 3 for more information.
• SATA 0, SATA 1, SATA 4 and SATA 5 support data transfer rate up to 3Gb/s