DFI PIC-H61 - Manual (Page 23)

www.dfi .com
23
Chapter 2 Hardware Installation
Chapter 2
FPD Connector
FPD
KB/MS Connector
KB/MS
The KB/Mouse connector is used to connect PS/2 keyboard and PS/2 mouse by means of a
PS/2 cable.
Connecting the PS/2 Cable
The system board package comes with a PS/2 cable. Connect one end of the cable to the KB/
Mouse connector. The other ends are used to connect a PS/2 keyboard and a PS/2 mouse.
1 2
10 9
KBCLK
GND
KEY
KBDATA
KBMS POWER
MSCLK
MSDATA
GND
GND
KBMS POWER
PS/2 keyboard port
PS/2 mouse port
Connect to the
board’s KB/Mouse
connector
Wake-On-PS/2 Keyboard/Mouse
The Wake-On-PS/2 Keyboard/Mouse function allows you to use the PS/2 keyboard or PS/2
mouse to power-on the system.
The FPD connector supports a standard floppy disk drive. The floppy cable can be inserted
into this connector only if pin 1 of the cable is aligned with pin 1 of this connector .
Connecting the FPD Cable
Insert one end of the FPD cable into the FPD connector and the other end of the cable to the
floppy drive. Pin 1 of the cable must align with pin 1 of the FPD connector.
BIOS Setting
Enable or disable this function in the Advanced menu (“Floppy Configuration” section) of the
BIOS. Refer to chapter 3 for more information.
33
34 2
1