Datalogic Scanning MATRIX 1000 - Manual (Page 10)

viii
GUIDE TO INSTALLATION
The following can be used as a checklist to verify all of the steps necessary for
complete installation of the Matrix-1000
 compact 2D reader.
1) Read all information in the section "Safety Precautions" at the beginning of this
manual.
2) Correctly mount the reader using the bracket provided (sub-pars. under 2.2).
3) Position the reader at the correct reading distance according to your model
(par. 2.5).
4) Make electrical connections to your Matrix-1000™ reader by either:
a) Connecting the test cable to the Matrix-1000™ reader (par.2.4).
b) Providing correct and complete system cabling according to the signals
necessary for the layout of your application.
•
Layout: Point-to-point or Multidrop, etc. (sub-pars: 2.6);
•
Cabling: Power, Main RS485, Auxiliary RS232, External Trigger Input
and Output (sub-pars. under 2.3).
5) Configure the Matrix-1000™ reader by installing and running VisiSet™ from the
CD-ROM provided onto the configuration PC (pars. 3.1, 3.2, 3.3). See the
Rapid Guide to Configuration in the VisiSet™ Help On Line. The main steps
are:
a) Select the codes to be read
b) Set-up the communication parameters
c) Define data formatting parameters
d) Fine tune your Matrix-1000™ reader using the VisiSet™ Calibration Tool
(par. 3.4.2).
Specific VisiSet™ parameter details are also available in the Help On Line.
6) Exit the configuration program and run your application.
The installation is now complete.