DNF Controls 4040CL-EVS-PBIO - Manual (Page 10)

4040CL-EVS-PBIO, 300 Clip Fast Access System, EVS DDRs Page 10 of 26
7) Select the VTRs to learn by pressing VTR keys [1], [2], [3], [4], [5], and or [6].
8) Press
[LEARN] to complete the learn process.
NOTE: LEARN will overwrite the previous contents of the Shotkey.
Press [ESC] at anytime to escape without LEARNing.
7. RECALL A CLIP OR CLIP COMBINATION
a. RECALL A CLIP FROM THE PRODUCTION
SWITCHER
1) On the ST400 in the SETUP MENU, set the desired PB addresses for the
selected ST400 VTR channels that will be controlled by the Production Switcher.
2) On the Production Switcher, select and enable the PB addresses for the ST400
VTR channels that will be controlled.
3) On the Production Switcher, recall the desired REGISTER.
The ST400 will automatically load the Learned clips on the Learned VTRs, set the
Learned IN and OUT points, cue the clips to the Learned IN point, set the Learned GANG
mode.
b.
RECALL A CLIP FROM THE ST400
1)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom of the display.
2) Press
[LOAD] on the ST400.
The ST400 will automatically load the Learned clips on the Learned VTRs, cue
the clips to the Learned IN time, then set the Learned GANG mode.
8. RECUE CLIP
a. Press
[RECUE]. If an IN Point is marked (the IN indicator is on), the clip will RECUE to
the IN Point.
b. Press
[CUE OUT] to cue to the marked OUT point.