DR Power 6000-Watt Generator - Manual (Page 14)

10 DR
®
GENERATOR ATTACHMENT
9. Bolt the Crosspiece to the front of the Skids (Figure 4) using four (4) Bolts, Washers, and Lock
Nuts. Now tighten all of the hardware.
10. Tip the unit up right onto the Skids. The assembly is now complete.
NOTE: Do not discard your packaging material until you are fully satisfied with your new DR GENERATOR
ATTACHMENT.
Figure 1
1. 2. 3. 4.
Top Packing Material
Packing Material
Skids
Crosspiece
Bolt Heads
and Washers
(2 places
each side)
Bolt Heads and
Washers (1 place
each side)
Bolt Heads and
Washers (4 places)
Frame
Skid Inside Frame U-Channel
Crosspiece
Skid
Generator Wire
Harness
Frame
Channel
Front Rear
Figure 2
Figure 3
Belt Guide Bolt
Assembly
Spacer
Lock Washer
Bolt
Generator Wire
Harness
Figure 4