DR Power Tow-Behind 13.74 Pro-XL (August 2010 - August 2014) - Manual (Page 11)

CONTACT US AT www.DRpower.com 11
Assembling the Collector, Impeller Outlet Duct and 28" Hose with
Cuff
Tools Needed:

Two 1/2" Wrenches

3/8" Wrench
1. Position the Collector Base at the rear of the Frame and line up the Collector
Base Pivot Tubes with the Frame Pivot Brackets. Secure the Collector Base
to the Frame with two Clevis Pins (heads facing in) and Hitch Clips (Figure
7).
2. Lower the Collector Base down onto the Frame to lock the Lift Handle fully
into the Dump Latch.
NOTE: The Side Panel Assemblies must be installed with the correct edges facing
front and rear (Figure 8).
3. Position a Side Panel (with DR logo right side up and facing out) bottom
groove onto the Lip at the side of the Collector Base.
4. Support the Panel as you slide a Corner Bar into the rectangular opening at
the rear and down into the Collector Base hole at the bottom. You may need
to lift the ends of the Side Panel a bit to get the threaded Bar end into the
Collector Base hole.
5. Slide another Corner Bar into the rectangular opening at the front of the
Panel and down into the Collector Base hole at the bottom.
NOTE: You may need to tap lightly on the top of the Panels to get the slot to lock
together properly with the Base Lip.
6. Follow steps 3 thru 5 for the other Side Panel.
7. Slide the Front Panel (with Labels right side up and facing out) into the
Grooves at the front of both Side Panels and push it down until the groove at
the bottom of the Front Panel slides over the Lip in the Collector Base
(Figure 9).
8. Place the Top Cover over the Front and Side Panels (Inlet hole in separator
facing forward) and position so the Corner Bar threads protrude through the
holes at the corners of the Top Cover.
9. Install a Washer and Low Profile Locknut to the top and bottom of each Bar
only hand tight for now.
Right
Side
Panel
Figure 8
Collector
Base
Front Edge
Detail Rear Edge
Detail
Front Lip
Position
Bottom End of Bar
Bar
Bar
Collector
Base
Hole
Bar
Left
Side
Panel
Collector Base
Pivot Tube
Figure 7
Frame Pivot
Bracket
Clevis Pin
Hitch Clip
Frame
Collector
Base
Lift Handle
Separator
Inlet Hole
Figure 9
Nut and Washer
(both ends)
Top
Cover
Front
Panel