DR Power RapidFire 6 HP Subaru (July 2012 - Aug 2013) User Manual

Page 10

Advertising
background image

10

DR

®

RAPIDFIRE™ LOG SPLITTER

Operator
Zone

Figure 6

TOP VIEW

Operator
Zone

Chapter 3: Operating The DR RAPIDFIRE LOG SPLITTER

It may be helpful to better familiarize yourself with the features of your Log
Splitter by reviewing Figure 1 in Chapter 2 before beginning the steps outlined in
this chapter.

Starting the Engine

Note: See the Engine Manual for more detailed and specific information on
operating the Engine.

1. Position your Log Splitter on flat, dry ground.

2. Make sure the fuel shut-off valve is in the “ON” position (Figure 7).

3. Move the choke control lever to the CHOKE position to the left (should only

be needed if the engine is cold).

4. Move the throttle control lever to the FAST “Rabbit” position.

5. Manual Start: Turn the Ignition Switch to the “On” position (Figure 8).

Grasp the recoil starter handle and slowly pull until you feel resistance
(Figure 7). Let the cord retract a little bit then pull the cord rapidly to start
the engine. One or two pulls usually starts the engine.

6. Electric Start: Turn and hold the Key in the “Start” position until Engine

starts then let the Key return to run position (Figure 8).

7. Move the choke control lever (if used for cold engine) slowly back to the

OPEN position (to the right) when the engine is running well (Figure 7).

Note: If the Log Splitter has not been running (cold engine), warm up the engine by
running the engine at half throttle for 3 to 4 minutes, then advance the engine
throttle control to maximum speed.

Stopping the Engine

1. Move the Throttle Lever to Idle “Turtle” position.

2. Manual Start: Turn the Ignition Switch to the “Off” position (Figure 8).
3. Electric Start: Turn the Key to the “Off” position.

Fuel Shut-off
Valve

Figure 7

Choke Control
Lever

Throttle Control
Lever

Recoil Starter
Handle

Key Switch

Start

Run

Off

Figure 8

Electric Start
Engine

Manual
Start
Engine

Ignition Switch

On

Off

Read and understand all instructions, safety precautions, and/or
warnings listed in “Chapter 1 General Safety Rules” before operating this
DR RAPIDFIRE LOG SPLITTER. If any doubt or question arises about the
correct or safe method of performing anything found in this manual,
please contact our Customer Service Representatives at our toll free
number: 1-800-DR-OWNER (376-9637).

When operating the Log Splitter, make sure you are standing in the safe
operating area (OPERATOR ZONE) as shown in Figure 6. You must stay
in the safe operating area at all times when the ram is in motion (whether
extending or retracting). Never place any part of your body into a position
that causes an unsafe operating condition.

Advertising
This manual is related to the following products: