DR Power 22-Ton (July 2013 - Present) - Manual (Page 21)

CONTACT US AT www.DRpower.com 21
a) Remove the vented reservoir dipstick, which is located next to the engine on top of the reservoir tank (Figure 16).
b) Check the fluid level using the dipstick. Also refer to (Figure 25 and Figure26 on Page29).
c) Replace the vented dipstick.
d) Make sure the Engine is in the “STOP” position and disconnect the spark plug wire from the spark plug. Prime the
pump by pulling the recoil starter as far as it will go. Repeat approximately 10 times.
e) Reconnect the spark plug wire and start the engine, following instructions in Chapter 3.
f) Use the control handle to engage the wedge to the farthest extended position. Then retract the wedge.
g) Refill the tank as needed so the fluid just touches the end of the dipstick.
Note: Failure to refill the tank will void the splitter’s warranty.
h) Extend and retract the wedge 12 complete cycles to remove any trapped air in the system (the system is “self-
bleeding”
i) Refill the tank as needed so the fluid just touches the end of the dipstick.
(Figure 16)