DR Power Hydraulic 8-Ton - Manual (Page 11)

Contact us at www.DRpower.com 11
Unpacking the Crate
1. Cut the banding (tin cutters) and pull the box off the
pallet.
2. Cut the tape (utility knife) and open the box. Pull out
both Support Inserts (Figure 2).
3. With a person at each end of the box, lift the plywood
base that the Splitter is attached to, out of the box.
4. Cut the remaining banding strap and Cable Ties (tin
cutters) (Figure 3).
5. Open the Parts box, and make sure all the smaller
parts have been shipped (Figure 4). The chart in the
“Shipping List” (previous page) provides a complete
list of all the parts shipped with your Wood Splitter. If
you have any questions, please contact us at
www.DRpower.com or call DR Power Equipment at 1–
800-DR-OWNER (376-9637).
Figure 3
Parts
Box
Cable
Ties
Plastic
Banding
Figure 2
Support
Inserts
Figure 4
Hardware
Package
Two 8"
Tires
Front Leg
with Rubber
Foot
WEAR EYE PROTECTION WHEN CUTTING THE BANDING.
THE BANDING MAY HAVE A LOT OF TENSION ON IT AND
MAY SNAP AND CUT YOU. ALWAYS STAND TO ONE SIDE
WHEN CUTTING THE BANDING.
THE WOOD SPLITTER WEIGHS APPROXIMATELY 140
LBS. WE RECOMMEND TWO PEOPLE FOR STEP 3.
BE CAREFUL WHEN WORKING NEAR THE SPLITTING
WEDGE. THE WEDGE CAN EASILY CUT OR PUNCTURE
THE SKIN IF YOU CONTACT IT AT THE POINTED TOP
CORNER OR SHARP FRONT EDGE.