DR Power Hydraulic 8-Ton - Manual (Page 12)

12 8-TON DR ® WOOD SPLITTER
Assembly Procedure
Securing the Cylinder and Push Plate Assembly
6. Slide the Cylinder and Push Plate Assembly towards
the Engine until the Trunnion Pins on the side of the
Cylinder fit into the slots of the Cylinder Mounting
Bracket (Figure 5).
7. Install the two Cylinder Retainer Plates using four 5/16
x 3/4 inch long Hex Bolts and Locknuts (Figure 6).
Tighten the Nuts securely (1/2 inch wrenches).
8. Push the Low-Pressure Hose onto the Fitting (Figure
7).
9. Loosen the Hose Clamp (flathead screwdriver) and
slide it up over the end of the Low-Pressure Hose and
tighten.
10. Thread the High-Pressure Hose onto the Control
Valve Fitting and tighten (crescent wrench).
Figure 7
High -Pressure
Hose
Low -Pressure
Hose
Hose
Clamp
Figure 6
Cylinder
Retainer
Plate
Bolt and
Locknut
READ ALL INSTRUCTIONS AND SAFETY RECOMMENDATIONS BEFORE ASSEMBLING OR OPERATING
THIS WOOD SPLITTER.
Figure 5
Cylinder
Mounting
Bracket
Cylinder and
Push Plate
Assembly
Trunnion
Pins