DR Power Hydraulic 22-Ton - Manual (Page 15)

Contact us at www.DRpower.com 15
3. While supporting the hinge bracket (Figure 7), pull the
hairpin clip and remove the hinge pin to separate the
hinge bracket.
4. Pull out and twist the locking lever to lock it in the out
position.
NOTE: For the next step, use the third set of mounting holes
up from the Base Plate.
5. Make sure the notch is on top as you position the
hinge bracket onto the rail assembly (Figure 8). Install
two 1/2-13 x 1-1/2 inch long hex head bolts, lock
Washers, and nuts. Only hand tighten the nuts at this
time.
6. Position the base unit against the rail assembly
(Figure 9).
Figure 8
Hinge Bracket
(mount in the
third set of
holes up from
the Base Plate)
Bolts (far side),
Lock Washers
and Nuts
Rail
Assembly
Notch on
top
Base Plate
Figure 7
Hinge
Bracket
Hairpin
Clip
Hinge
Pin
Locking
Lever
Figure 9
Rail
Assembly
Base Unit
HAVE SOMEONE HOLD THE RAIL ASSEMBLY TO PREVENT
IT FROM FALLING DURING THIS PART OF THE ASSEMBLY.