DR Power 8 FPT - Manual (Page 12)

12 DR ® CHIPPER/SHREDDER
Check the Tire Pressure
Tools Needed:

Tire Pressure Gauge

Air Compressor or Hand Pump
1. Remove the Valve Stem Protective Cap (Figure 9) and check the Tire
pressure with a Tire Pressure Gauge.
2. Check the manufacturers recommended pressure that is stamped on the
side of the Tire.
3. If the pressure is too low, add air through the Valve Stem with an Air
Compressor or Hand Pump.
4. Replace the Valve Stem Protective Cap when finished.
Do not over inflate the Tires. Inflate to the manufacturers recommended
pressure.
Valve Stem
Protective Cap
Figure 9