ESI Waveterminal U2A - Manual (Page 21)

2 1
desired sampling rate. Now the sampling rate of the signal you can get
from digital output port is converted.
However, you cannot change the sampling rate of .wav file that
playback through the application. If you try to convert it, it only
sounds like sampling up (faster speed than normal) or sampling down
(slower than normal).
D I G I T A L O U T ( I E C 9 5 8 ) T Y P E
Digital Out Type selector determines the type of data format to be
used on the digital output jack of U2A.
1. CONSUMER (IEC 958 Type II)
Generally known as S/PDIF (Sony Phillips Digital Interface),
select this mode if you are sending digital audio output from
U2A to a S/PDIF equipped audio device.
2. PROFESSIONAL (IEC 958 Type I)
Generally known as AES/EBU, select this mode if you are
sending digital audio output from U2A to an AES/EBU audio
device.
Important Notice: Since the adaptation of IEC958 no longer
distinguishes between S/PDIF and AES/EBU, some of the
older AES/EBU audio equipment require a higher signal level
than U2A’s digital output levels (which conform to IEC 958
standards). If you experience problems transferring digital
audio from U2A to an AES/EBU equipment, you may need a
signal converter such as EGO SYS’s Dr. D to boost the level.
B O T T O M O F T H E C O N T R O L P A N E L
1. exit
Close U2A Control Panel.
3. reconnect