ESI Waveterminal U2A - Manual (Page 30)

3 0
Specifications
1. Input Level : -10dBV Unbalance : -10dBV Nominal, +9.0dBV Max
2. Output Level:-10dBV Unbalance : -10dBV Nominal, +8.5dBV Max
3. Input Impedance :Unbalanced Mode 10K
4. Output Impedance :Unbalanced Mode 100
5. Analog Input Gain/Attenuation : Analog 0dB ~ 18dB, 0.5dB Step Size
Digital -72dB ~ 0dB, About 0.5dB Step Size
6. Analog Output Gain/Attenuation : Digital -72dB ~ 0dB, About 0.5dB Step
Size
7. Sample Rate : 32KHz,44.1KHz,48KHz
8. A/D Spec
1) Type : AKM Semiconductor, 24Bit, 64x Oversampling
2) Dynamic Range : 100dB A-Weighted, AT -60dBFS measurement
method
3) Signal-to-Noise Ratio : 100dB A-Weighted
4) S/(N+D) Ratio : 90dB, AT -0.5dBFS measurement method
5) Interchannel Gain Mismatch : 0.2dB
6) Frequency response : 0 ~ 20KHz (FS=44.1KHz)
9. D/A Spec
1) Type : AKM Semiconductor, 24Bit, 128x Oversampling
2) Dynamic Range :
110dB A-Weighted AT -60dBFS measurement method
3) Signal-to-Noise Ratio : 110dB A-Weighted
4) S/(N+D) Ratio : 94dB, AT -0.5dBFS measurement method
5) Interchannel Gain Mismatch : 0.2dB
6) Frequency response : 0 ~ 20KHz (FS=44.1KHz)
10. Digital I/O Spec
1) Type : Crystal Semiconductor
24Bit Digital Audio I/O with Sample rateConverter
2) Format : IEC60958,AES3,S/PDIF,EIAJ CP1201
3) Sample Rate : 32KHz, 44.1KHz, 48KHz
4) Resolution : 24Bits
5) Sample Rate Converter :
128dB Dynamic Range
1:3 & 3:1 Maximum input to output sample rate ratio