ESI Waveterminal U2A - Manual (Page 27)

2 7
7. Trouble Shooting
Before you rush to consult your problem to us, please check this
section for immediate remedy. You may find simple solution here
without consuming time that you wait for the answer through e-mail.
þ I finished to install the hardware and software, but I cannot hear
the sound through my monitor system.
- You may need to check U2A is installed properly. If USB plug
were not inserted correctly into the USB port, computer would
show a message. Check the connection, if you connect output port
of U2A to the input of amp/mixer to monitor.
- The other thing to check – control panel of U2A. To monitor the
sound of wave file, “USB Wave Out” should be selected from
“ANALOG OUT MIXER” section. If you want to monitor input
source, you need to check either “Analog In” or “Digital In”.
- Clock Source selection is another important thing to check. If you
select “DIGITAL IN” for the Clock Source, you won’t record or
playback wave file from the computer. This mode initiates U2A to
function as an independent converter device.
þ Playing back sound is too slow (fast) compare to the original file.
- Please check if you select “Internal” for the CLOCK SOURCE
and turn the “Auto Set” on. If you select other than “Internal” for
the clock source, you cannot control the sampling rate section. .
l Please visit our website at www.egosys.net for more
information. We will update the FAQ and trouble shooting
through the website. If there is a problem you cannot find the
solution through the Trouble Shooting or FAQ, feel free to
contact us.