FiberPlex VIM-MY32 - Manual (Page 10)

10
The VIM‐MY32MT4, VIM‐MY32MOC and VIM‐MY32MST are identical with one exception. The T4 version contains a single TAC‐4 fiber
connector, The OC version contains a single Neutrik OpticalCon fiber connector, and the ST version contains a pair of ST fiber
connectors. The VIM‐MY32T4 (Master) and VIM‐MY32S (Slave) card are shown here. Drawings of all versions can be found on page 14.
VIM‐MY32M – Master Card
Neutrik MiniCon Connector – This (12) pin connector is used to connect the VIM‐MY32M master card to the VIM‐MY32S slave
card.
Slave LED – This LED shows the status of your connection between your master and slave cards. If the LED is not lit, there is no
connection. If the LED is flashing green this means the slave card is present but not in sync. If the LED is solid green, the connection
between master and slave cards is active and in sync.
Sync LED – This LED indicates the clock sync status of the system. If the LED is not lit, the card is not receiving power. If the LED is
flashing green this means the system is searching for sync. If the LED is solid green the system is in sync.
ST Fiber Pass Through Connectors – These fiber “pass‐throughs” appear only on the VIM‐MY32MT4 version of master card. These
pass troughs allow you to access the additional (2) fibers in a TAC‐4 connectos and connect them with the additional VIM‐MY32MST
master card in systems with 48 or 64 channels. On a 32channel system, these ST “pass‐throughs” would not be used as there is only
(1) master required for a 32x8 system. They could however be used to connect additional external fiber devices such as a LightViper
EF‐2 Physical Layer Ethernet converter.
Fiber Connector – The main fiber connection illustrated above contains a TAC‐4 connector. Other versions contain either a single
Neutrik OpticalCon fiber‐optic connector, or (2) ST fiber‐optic connectors.
VIM‐MY32S – Slave Card
Neutrik MiniCon Connector – This (12) pin connector is used to connect the VIM‐MY32M master card to the VIM‐MY32S slave
card.
TTL CTL Connector – This connector is for use with the LightViper DGL‐422 control cable, MD3 Multi Interface Converter or DMX4
DMX Lighting Converter, as well as any future TTL based LightViper accessory units.
CTL / SEL Switch – This switch determines which connector on the VIM‐MY32S (Slave) card is active. Switch to the left for RJ45
“TTL CTL”, center for LS9 (“backplane”) control, and right for DB9 “HA” control.
HA/Remote Connector – This connector is for connecting a crossover DB9 to DB9 cable from the DB9 control output connector
on the Yamaha console to the DB9 on the VIM‐MY32S card.
9
8
7
6
5
4
3
2
1
5
6
7
8 9
VIM-MY32MT4 (Master) VIM-MY32S (Slave)
1
2 3
4