Caution, General installation instructions, Important safety instructions attention – FiberPlex VIM-MY32 User Manual
Page 4: Warning
4
Caution
Failure to observe the following precautions may lead to personal injury, or may result in damage to equipment or other
property.
Do not touch the board’s metallic leads (pins) when handling the card. (Pins are sharp and may cause
hand cuts.)
The card is electrostatic‐sensitive. Before handling the card, you should briefly touch the main unit’s
metal casing with your bare hand so as to drain off any static charge from your body.
General Installation Instructions
Please consider besides these general instructions also any product‐specific instructions in the “Installation” chapter of this
manual.
When installing or removing LightViper VIM‐MY32 cards in any Yamaha console with YGDAI card slots, please pay close
attention to the following instructions.
1. Only use the VIM‐MY32 cards with Yamaha digital consoles containing YGDAI card slots
2. ALWAYS BE CERTAIN TO POWER DOWN THE CONSOLE WHEN INSTALLING OR REMOVING THE VIM‐MY32 CARDS.
Important Safety Instructions
ATTENTION:
RISQUE DE CHOC ELECTRIQUE – NE PAS OUVRIR
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products. The
lightning flash with arrow point in an equilateral triangle means that there are dangerous voltages present within the unit. The
exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner’s manual.
These symbols warn that there are no user serviceable parts inside the unit. Do not open the unit. Do not attempt to service
the unit yourself. Refer all servicing to qualified personnel. Opening the chassis for any reason will void the manufacturer’s
warranty. Do not get the unit wet. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service.
Disconnect the unit during storms to prevent damage.
Marking and warning information is provided on the bottom of the apparatus case.