FiberPlex VIM-MY32 - Manual (Page 3)

3
Warning for Your Protection
1. Read these instructions
2. Keep these instructions
3. Heed all warnings
4. Follow all instructions
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of the polarized or grounding‐type plug. A polarized plug has two blades with one wider
than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are
provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to
avoid injury from tip‐over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power‐supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
The apparatus shall not be exposed to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the
apparatus.
“WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.”
Warning
Failure to observe the following warnings may lead to risk of serious injury from fire or electric shock. Before installing the card,
you must refer to the owner’s manual of the host device or to the Yamaha website to verify that your host device supports this
card, and to verify the number of cards that can be installed in combination with other Yamaha or third‐party cards.
 Do not attempt to disassemble or modify the card.
 Do not apply excessive force to board connectors or other board components. (Mishandling the
board may lead to shock, fire hazard, or equipment failure.)
 You must turn off the power of your device before you begin installing the VIM‐MY32 card.
 Be sure to disconnect the power cable from the main unit before installing this card (to eliminate
shock hazard).