FiberPlex VIM-MY32 - Manual (Page 13)

13
LightViper VIM‐MY32 Card Specifications
1. General Specifications
Total Harmonic Less than 0.01% 1 KHz @ +4 dBu
Frequency Response ± 0.5 dB 20-20kHz @ +16 dBu
Dynamic Range 102 dB
Crosstalk 5 dB above noise floor
Sampling Rate 24 bit / 48 kHz
Latency 10 s one way digital
Operating Temp 0 to +50°C ambient temperature.
Slave LED LED (green) indicates that VIM-MY32S Slave card is present and in sync. LED (flashing) indicates Slave card is present but not in sync. LED (off) indicates no Slave card present.
Sync LED LED (green) indicates optical link OK, LED (flashing) indicates problem with optical link, LED (off) indicates no power.
AC Power N/A
Max Current Rating VIM-MY32M
VIM-MY32S
3.5 W from card slot
3.5 W from card slot
On / Off Control RJ-45 connector for logic level control, CMOS or TTL at 2 MHz max per channel.
Dimensions VIM-MY32M
VIM-MY32S
6.392" L X 4.740" W X 1.575” H (161mm X 100mm X 40mm)
6.392" L X 4.740" W X 1.575” H
Weight VIM-MY32M
VIM-MY32S
0.8 lbs (0.4 Kg) max
0.4 lbs (0.2 Kg)
*1-Hum & Noise are measured with an AES17 compliant filter at 20 kHz. Temperature condition @+10 - +25° C.
HA Connector Pin Outs
1. Unused
2. RX
-
3. TX -
4. TX +
5. Ground
6. RX
+
7. Unused
8. Unused
9. Unused
Control Circuits RJ-45 Pin Outs
1. GND
2. TX1
3. TX2
4. TX3
5. RX1
6. RX2
7. RX3
8. VCC
+5VDC
This page intentionally left blank