Fieldpiece ACM3 - Carbon Monoxide Accessory Head - Manual (Page 2)

Storage
Do not store in areas which contain solvent
vapors. This includes aerosols such as air-freshen-
er, wax polish, window cleaner, and all organic sol-
vents.
Calibration
Because the chemical sensor can be degraded
by exposure to harmful chemicals, dirt and other
contamination, high temperatures, and extremes in
humidity, periodic calibration can maintain accuracy
of the sensor over time. Drift is expected to be less
than 5%/year in most cases but is dependent on
use.
Optional pump
Use the model AOXP2 pump to extract ambient
air samples from hard to reach places or from loca-
tions where the air temperature is high.
For potentially high concentrations of CO, pump
slowly and stop if the measurement approaches
2000PPM.
Carbon monoxide concentrations will begin to be
shown in two or three squeezes. For final reading,
pump until the reading stabilizes--approximately 30
squeezes.
Press MAX on DMM to hold highest reading.
AOXP2
Connect ACM3 in multiple ways
EHDL1 HS series AHDL1 w/ Meter
Cross-sensitivity
The sensor has a permanent unreplaceable filter
built inside the sensor to filter out trace concentra-
tions of SO2, NO2, and most hydrocarbons. If
exposed to high concentrations of harmful chemi-
cals or dirt, the filter can deteriorate and/or impede
diffusion of air to the sensor.
One Year Limited Warranty
This head is warranted to the original purchaser
against defects in material and workmanship for a
period of one year from the date of purchase.
During the warranty period, Fieldpiece will replace
or repair the defective unit, subject to verification of
the defect.
Any damage to the sensor from dirt, mechanical
abuse, or overexposure to damaging chemicals,
including overexposure to carbon monoxide, are
not covered under this warranty. Also not covered
are defects resulting from abuse, neglect, accident,
unauthorized repair, alteration, or unreasonable
use.
ANY IMPLIED WARRANTIES ARISING OUT OF
THE SALE OF A FIELDPIECE INSTRUMENT
PRODUCT, INCLUDING BUT NOT LIMITED TO
IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE,
ARE LIMITED TO THE ABOVE. FIELDPIECE
SHALL NOT BE LIABLE FOR LOSS OF USE OF
THE INSTRUMENT OR OTHER INCIDENTAL OR
CONSEQUENTIAL DAMAGES, EXPENSES, OR
ECONOMIC LOSS, OR FOR ANY CLAIM OR
CLAIMS FOR SUCH DAMAGE, EXPENSES, OR
ECONOMIC LOSS.
Local laws vary. Above limitations or exclusions
may not apply to you. This warranty gives you spe-
cific legal rights, and you may also have other rights
which vary by location.
Service
Return any defective ACM3 to Fieldpiece for war-
ranty service along with proof of purchase. Contact
Fieldpiece for out of warranty repair charges.
Fieldpiece Instruments, Inc.
California, U.S.A.
www.fieldpiece.com
Gas PPM
Cross
sensitivity %
Hydrogen
sulfide
207 1.3
Sulphur
dioxide
208 -0.7
Nitric
oxide
1000 46
Nitrogen
dioxide
20 -4.4
Chlorine 15 -3.8
Hydrogen 200 78
Hydrogen
cyanide
15 -0.5
Hydrogen
chloride
135 -0.7
Removable rubber strip
Use your calibration tool that comes with the
ACM3 to zero adjust.
v07