Fire Magic Regal I 34 series Drop In - Manual (Page 14)

14
1. Make sure that your gas supply is turned OFF. Then connect the stainless steel fl ex connector to the gas
supply stub. Use pipe joint compound that is resistant to all gasses on the male pipe fi tting and tighten
securely. Do not use pipe joint compound to connect fl are fi ttings.
2. If you have not already done so, lower your barbecue into place, making sure not to pinch or kink the gas
connector.
3. Bring the fl ex connector up to the regulator found on the right side of the unit.
4. Connect the fl ex connector to the adapter on the regulator. Support the regulator adapter with a wrench
to avoid applying excessive torque to the assembly while tightening this connection securely. Do not use
pipe compound on the fl are fi tting.
5. Make sure the barbecue burner valves are in the OFF position. Turn the gas supply on. Then carefully
check all gas connections for leaks with a brush and soapy water before lighting. NEVER USE A MATCH
OR OPEN FLAME TO TEST FOR LEAKS.
6. Place a disposable liner in the provided drip tray. Hook the drip tray onto the two slots found on the right
side of the grill.
Note: Disposable liners (mini-loaf pans) are available at many stores. For your convenience, the drip pan
holder is designed so an empty 14 to 18 ounce (.41 lt to .53 lt) tin can may be substituted for the drip
pan and drip pan support.
7. Screw the two 1 1 /
4
" (2.8 cm) stabilizer screws (packed with the instructions) into the threaded inserts in
the right rear corner of the frame assembly. This will secure your barbecue in place.
8. If removed, replace the top panel. Be sure to reattach the ignitor wires. The top panel may be adjusted left
to right for bezel alignment with gas valve knobs.
9. If removed, replace the burner control knobs.
INSTALLATION
CONNECT THE GAS SUPPLY
For propane cylinders:
For connecting a propane unit to a portable propane tank, read the safety warnings and follow the instructions in
the section SAFE USE AND MAINTENANCE OF PROPANE GAS CYLINDERS.
Note: When a propane cylinder is installed inside of the enclosure, the guidelines found in the ENCLOSURE
REQUIREMENTS section MUST be followed.
For household propane or natural gas units:
CAUTION: Use only C.S.A. listed stainless-steel fl ex connectors within the enclosure.
WARNING
A rubber or plastic connector will rupture or leak, resulting in an explosion or serious injury if used
inside the appliance enclosure.
Installation can be completed by accessing the unit through the access panel on the right side of your enclosure.
Alternatively, the top panel may be removed (see CHECKING/CONVERTING THE BURNER ORIFICES section).