Fire Magic 3682 Warming Rack Extender - Manual

REV 0 - 1404240816 L-C2-432 1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
COOKING AREA: 14" x 7"
This warming rack extender is for use with the following
grill series only:
A530, A660, A790,
E660, E790, & E1060
ASSEMBLY & INSTALLATION
1. Ensure the grill is completely cool, the knobs
are in the off position, and the gas supply to
your grill is turned off.
2. Wash all of the warming rack extender components
(with soap and water) before assembly.
3. To assemble, carefully slide the brackets onto the
tray as shown in Fig. 1-1 "A". Snap the brackets
in place. See Fig. 1-1 "B".
4. Open grill oven hood.
5. Position the extender above the warming rack, lower
the hooks into the rear of the rack, then lower the front.
The bottom of the extender has grooves that rest on
the front of the warming rack. See Fig. 1-2 and 1-3.
6. Repeat if additional extenders were purchased.
The extender may be removed and stored when desired.
DISASSEMBLY FOR CLEANING
It is recommended that the warming rack extender be
cleaned after each use. It can easily be disassembled
and fi t in a dishwasher.
1. Remove the warming rack extender(s) from the
grill and disassemble by reversing the instructions
in step 3 above.
2. Clean as needed.
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
WARMING RACK EXTENDER
Model # 3682
Fig. 1-1 Assemble warming rack extender
Fig. 1-3 Warming rack extender in place
Fig. 1-2 Install warming rack extender
A
B
B
A
Grooves must
align to front bar
when lowered