Fire Magic 3000-0x Legacy Liner Replacement Kit - Manual

REV 0 - 1408141310 L-C2-433 1
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
Fig. 1-1 Remove grill components
Liner Replacement Kit
This liner is for replacement on Regal and Custom Series Grills.
Installation on a Custom II model is shown here. Installation on
other models may slightly vary. To install, follow the steps below:
1. Be sure the barbecue is completely cool and the gas is
completely shut off.
2. Remove the warming rack, cooking grids, fl avor grids, burners,
control panel, igniters, and oven hood (if applicable). See Fig.
1-1. Reference your owner's manual for complete removal
details if needed.
Important: If the oven hood is equipped with a back burner,
the gas line and igniter wire to the back burner
must be disconnected in order to remove the oven
hood (if applicable).
3. Remove any nuts and bolts from the existing rear wall and
discard. See Fig. 1-2.
Note: The discarded nuts and bolts will be replaced by new
nuts and bolts included with the replacement liner.
4. Clean the interior of the grill of all deposits and grease.
5. Carefully install the bottom liner as shown in Fig. 1-3.
6. Install the top liner ensuring that it rests fl at against the
original liner walls (see Fig. 1-4).
7. Replace all of the components removed for this procedure.
Series Kit Model #
Regal I 3000-08
Regal II 3000-07
Custom I 3000-01
Custom II 3000-03
Deluxe 3000-02
Table 1
Fig. 1-2 Remove nuts and bolts
Fig. 1-3 Install bottom liner
Custom II kit shown
Bottom
liner
Fig. 1-4 Install top liner
(Rear wall)
Remove ALL
nuts and bolts
(Top liner)