Fire Magic 3199-47 Spark Generator Replacement Kit - Manual

REV 4 - 1403060815 L-C2-193 1
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
SPARK GENERATOR
REPLACEMENT KIT
Models # 3199-47, 3199-48
Fig. 1-1 Spark generator parts
Generator
Locking
ring
Ignitor
cover
Rubber
battery cap
Fig. 1-2 Spark generator wires
Rear view showing
wires connected to
terminals.
Fig. 1-3 Remove battery cap
Turn ignitor cover to remove
and replace the generator
WRONG!
Fig. 1-4 Fasten ground wire
Where fi tted, ensure
that the ground wire
is securely fastened
t o t h e m a n i fo l d
mounting bolt (right
side).
Manifold
1. Ensure the grill is completely cool, the knobs are in
the off position, and the gas supply to your grill is
turned off.
2. Remove the valve knobs from the face or panel.
3. Remove the screws and fi nish washers securing the face.
4. Carefully remove the face.
CAUTION: The spark generator is attached to the face or
panel. Carefully unplug all wires from the spark
generator before pulling it away from the unit (see
Fig. 1-2).
5. Remove the battery cap by turning the ignitor cover
counter-clockwise (Fig. 1-3).
Note: Do not attempt to pull or turn the rubber cap (Fig. 1-3).
6. Hold the generator, and turn the locking ring counter-
clockwise. (It may be necessary to use pliers to get it started.)
7. Inspect the wires to make sure they are not cracked or
damaged. This can cause short-circuiting of the generator.
8. Install the new generator and new battery by following
steps 1 through 5 in reverse order.
9. Attach all wires to poles on the generator (order not critical).
Attach the ground wire, if necessary, to the manifold
mounting bolt on the right side (see Fig. 1-4). Use the nut
provided.
10. Check ignitors for spark when the generator button is
depressed.
11. Secure the face to the frame with the original face screws
and fi nish washers.
Note: When connecting the ignitor wires all terminals must be
occupied. If both of the terminals are used, no ground
wire is necessary. If using only one terminal, the second
MUST be used as a ground wire.
2-position model shown