Flowserve PMV D20 - Manual (Page 5)

5
WARNING:
Before products are returned to
FLOWSERVE for repair or service
FLOWSERVE must be provided
with a certificate which confirms
that the product has been
decontaminated and is clean.
FLOWSERVE will not accept
deliveries if a certificate has not
been provided (a form can be
obtained from FLOWSERVE).
1.8 Storage
In most cases FLOWSERVE products
are manufactured from stainless steel.
Products not manufactured from
stainless steel are provided with an
epoxy resin coating. This means that
FLOWSERVE products are well
protected from corrosion. Nevertheless
FLOWSERVE products must be stored
adequately in a clean, dry environment.
Plastic caps are fitted to protect the
flange faces to prevent the ingress of fo-
reign materials. These caps should not
be removed until the valve is actually
mounted into the system.
1.9 Valve and actuator
variations
These instructions cannot claim to cover
all details of all possible product
variations, nor in particular can they prov-
ide information for every possible
example of installation, operation or
maintenance. This means that the
instructions normally include only the
directions to be followed by qualified per-
sonal where the product is being used
for is defined purpose. If there are any
uncertainties in this respect particularly
in the event of missing product-related
information, clarification must be obtained
via the appropriate FLOWSERVE sales
office.
2. Unpacking
Each delivery includes a packing slip.
When unpacking, check all delivered
valves and accessories using this
packing slip. Report transport damage to the carrier
immediately.
In case of discrepancies, contact your
nearest FLOWSERVE location.