Formax FD 4040 - Manual (Page 10)

1. Slide mounting rods through holes in dryer (Fig 14a item A).
2. Loosen side rail screws.
3. Loosen side rails (Fig 9 items A & B pg 6), place dryer and rods between rails of conveyor (Fig 14a item A), align
with mounting slots in high or low position (Fig 14b item B) and secure in place with the 4 white Phillips head
screws supplied. Note: Mounting rods, screws and electric components supplied in dryer box.
4. Connect the dryer’s power cord to the receptacle on the back of the dryer (Fig 15a item C) and on the back of the
control panel module (Fig 15b item D). Note: The dryer receptacle is marked on the back of the control panel
module.
CAUTION! Do NOT connect dryer to a separate power source or dryer damage may result. Connect dryer power
cord only to outlet on conveyor, as shown below.
8
MOUNTING OPTIONAL D1000 1K DRYER
Mounting Rods
D C
Fig 15a
Fig 14a
B
A
Fig 15b
Fig 14b