Formax FD 4040 - Manual (Page 7)

4. CAUTION! This adjustment is necessary to avoid belt damage and eliminate a potential pinch point for safety.
Insert supplied card stock spacer (Fig 8a item A) between the belt and the out-feed bracket to set the spacing
between the bracket and the belt. Move the bracket in or out until a slight drag is felt on the card stock (Fig 8b
item B) and then tighten mounting screws (Fig 8c) . Remove card stock spacer and rotate belt and roller by hand
(Fig 8d) to ensure clearance at all points on the roller and belt. Readjust if belt contacts bracket.
5
Fig 8a
B
Mounting screws
A
Fig 8c Fig 8d
Ensure clearance between belt and bracket
Fig 8b